1, cleaning the tank, filters and piping, and check for corrosion, cracking collision case, shall not be used after washing with a fiber yarn, cloth wipe. 2, cleaning torque converter, transmission, inspect parts for wear, replace with new oil. 3, check the drive shaft bearing, depending on the need to exchange universal joint cross-axis direction. 4. Check the drive axle fastening ministries and whether leakage, and clear pores. Dismantling the main gear, differential, wheel reducer, adjust the bearing axial clearance, add or replace oil. 5, dismantling, adjustment and lubrication of the front and rear wheels, axle were transposed. 6, cleaning brakes, adjust the clearance between the brake drum and brake shoe lining between. 7, cleaning liberal amount of rotation steering, check the steering wheel. 8, disassembly and cleaning gear pumps, pay attention to check the wear of the gear housing and bearing. 9, demolition multi-way valve, the stem and the valve clearance check, do not open the safety valve, if not necessary. 10, check for damage and cracks knuckles, steering axle kingpin with the situation with the knuckle, dismantling the vertical and horizontal rod and steering arm joints wear. 11, removing a tire on the rim rust paint, check the tires and tubes and flaps, transposition accordance with the provisions inflated. 12. Check the connections are tight hand brake parts, adjusting the hand brake lever and foot brake pedal stroke work. 13. Check the battery electro-hydraulic proportion, as inconsistent with the requirements, the charge must be removed. 14, clean water tank and oil cooler. 15, check the shelves, frame without deformation, washable wheel, each accessory is reliable fixed, restocking weld if necessary. 16, dismantling the lifting cylinders, tilt cylinders and steering cylinder, replace worn seals. 17, check the instrument sensors, fuses and various switches, make adjustments if necessary. Fourth, the whole car or truck lubrication new truck stops working after a long time, within two weeks at the start of use, should be lubricated bearings for when lubrication, Chen should take advantage of new oil will all the oil out, and lubricate twice above, and should pay attention to the following points: 1, should be removed before lubricating oil cap, oil drain plug and nozzle above the dirt, dirt to avoid falling into the house. 2, with the grease gun lubricant injection pressure, injection pressure to be part of the components of the combination of the extrusion lubricant so far. 3, should be replaced in the summer or winter seasonal lubricant (oil, etc.). 5 tons diesel forklifts
